Lincoln Century 80GL Flux Cored WireFeed Welder K2501-1

The Century 80GL is a great tool for any garage or body shop. With its easy to operate controls and multiple power settings make this a great choice for the beginner or the hobbyest. Welds from 18 ga. sheet metal up to 1/8” steel in a single pass. Up to 88 full amps of welding power at 115 volts. A great unit for general purpose metal repair and building projects. Includes a 10’ mig gun, flux cored nozzle, tips, and a 1 lb. spool of .035 NR-211-MP wire.

Product Features

Century 80 GL welds 18 ga. sheet metal up to 1/8” steel
Great for general purpose metal repair and building projects
Two separate heat settings and an infinite wire speed control
Uses 0.035 flux core welding wire on a 4” spool. No shielding gas needed (ED027641)
Plugs into a standard 120 volt AC household outlet. No special wiring or receptacle needed
Safe cold wire design. Arc is not established until trigger is pulled
Sturdy wire feed design and multi-insulated transformer for reliable operation and long life

Recomended Processes:

The machine can be used for welding carbon and low-alloy steel through the self-shielded, Innershield® electrode process.
Innershield® NR-211-MP is a versatile wire suitable for all-position welding of light gauge or thin plate. It is recommended for maximum plate thicknesses in the range of 7.9 mm (5/16 in.) to 12.7 mm (1/2 in.). For an easy to use general fabrication wire – choose Innershield® NR-211-MP.

Operational Controls:
The machine has the following controls as standard:

Power ON/OFF Switch
Heat Range Switch
Wire Speed Control

Design Features:

Operates on 115 volt input
Solid state output control
Overload protection - incorporates a thermostat to protect the welder from overheating caused by malfunctions or overly heavy use
Permanent magnet wire drive motor
Easy-to-set controls for arc voltage and wire speed
Thumbscrew release idle roll pressure arm is easily adjusted
Reversible, dual groove drive roll
Accommodates spools of wire up to 1 lbs(0.5 kg) in weight
No external shielding gas is required

Welding Capability:

The machine is rated at 70 amps, 17 volts, at 20% duty cycle on a ten minute basis
It is capable of higher output currents at lower duty cycles

Limitations:

The machine is recommended for welding on mild steel up to 1/8” thick

Includes:

80GL with work clamp, Gun and cable assembly attached
Nozzle
One contact tip for .035(0.9mm) diameter
Starter spool of .035 (0.9mm) NR211-MP flux core wire
Operator’s manual

Warranty:

1 year parts and labor warranty on unit
90 days on welding gun and cable

Receive $15 Off if you place your order over the phone! (786) 242-9001

THESE ARE FACTORY REFURBISHED UNITS DIRECT FROM LINCOLN. THEY HAVE ASSURED ME THESE ARE SHIPPED IN "AS" NEW CONDITION. THESE WERE DEMOED AT SHOWS, SHOWN AT SHOWS, DAMAGED IN SHIPPING, RETURNED FROM DISTRIBUTORS OR FAILED INITIAL INSPECTION. ALL SHEET METAL IS REPLACED WITH NEW, AS DIS-ASSEMBLY IS REQUIRED TO RE-CERTIFY THEM UNDER THEIR ISO-9001 CERTIFICATION PROGRAM. ALL PARTS ARE INSPECTED AND REPLACED IF DEMOED. THEY ARE RE-PACKAGED IN NEW PACKAGING. THEY CARRY 1 FULL YEAR LINCOLN WARRANTY. IT'S A GOOD WAY TO SAVE CLOSE TO 10% OVER MY NORMAL DISCOUNTED PRICE.

For any Questions about this product call 786-242-9001
For More Items go to www.abweldingsupply.com